2GIG Edge - Product Bulletin Powering the Panel - Dated 05/13/21

PRODUCT BULLETIN

ISSUE DATE:
05/13/202
1
Powering the 2GIG EDGE panel (MUST READ)
GND
AUX+
GND
Bell +
Bell –
Zone 1
Zone 2
GND
DC IN
DC IN +
DC IN –
OCL 1
OCL 2
TX
RX
POWER IN
NOT USED FOR POWER
(DCOUT+)
For details, please refer to the
2GIG EDGE Quick Installation Guide
.
IMPORTANT
Never connect the plug-in power supply to a switch-controlled outlet.
DO NOT over-tighten terminal block contact screws.
Copyright © 2021 Nortek Security & Control LLC
Rev-X4
WARNING
Incorrect po
wer connection will damage the panel.
DO NOT
plug power
from transformer to
DCOUT+
or
AUX+
terminal blocks.
Correctly connect POWER IN from the transformer to
DC IN+
and
DC IN–

power connections on the panel (see below).