First Alert VISTAHTKVR-V - Data Sheet Dated 11/24

The VISTAHTKVR-V module allows for the addition of VLEX
devices onto a mid-level VISTAH Series system reducing the need
to pay more for a larger commercial system. VPLEX sensors
can be installed using two wires for power and data instead of
the traditional four, reducing wiring costs. These devices draw
minimal amounts of current minimizing the need for additional
auxiliary power supplies.
VPLEX devices continuously monitor and store functions in the
keypad event log that are reported to a central station drastically
reducing system maintenance costs when annual tests and
inspections are needed.
Specifications
•
4 modules supported, one for each partition
•
96 total devices, 172 input zones and 52 relay modules (4101SN’s)
are supported
•
2 built in tampers for for the removal of the cover or from

the wall
•
Communication is supervised so if wiring is cut a supervision

alarm signal will be sent
•
Can only be mounted remotely in the included plastic to gang box
or wall directly
•
Physical
: 6.93”W (176mm) X 5.43” H (138mm) X 1.99 D (50.5mm)
•
Electrical Input Voltage: 12VDC nominal (10-14VDC)
•
Electrical Input Current: 56mA. Note this does not include

powered devices using the AUX terminals.
•
Electrical Output Voltage: 12VDC nominal (10-14VDC)
•
Electrical Output Current: Reference the control panel

or power supply, AUX outputs Ratings – 1.3Max
•
Operating Temperature: 32 to 122 F (0 – 50 C)
•
Operating Humidity: 0 – 95% Relative Humidity
•
Power supply regulation on board – powered off the VISTAH3
controls power and battery backed up if panel losses AC.
VISTAHTKVR-V
VISTAH
®
Hybrid Series VPLEX Module V-Plex Sensor Compatibility
Sensor
Description
Sensor
Description
269SN
Hold up Switch
4939SN
Surface Mount Contact
4101SN
1 Zone + 1 Relay
4959SN
OHD Contact
4190SN
2-zone Expander
5193SD
Smoke Detector
4191SN
Recessed Contact
5193SDT
Smoke Detector
4193SN
1 zone Expander
DT8050A-SN
Dual Tec PIR, wiAnti-Mask
4193SNP
1 zone Expander
DT7500SN
Dual-Tec PIR
4208SN
8 Zone Expander
FG1625SN
Glass Break Detector
4208SNF
8 Zn Exp. w/Class A
IS2500SN
V-PlexISim Dual Tech
4208U'
8 Zone Expander
IS3050A-SN
Motion Detector
4209U*
4. 2-Wire Smoke Zn
VPLEX-VSI
V-Plex Short Isolator
* Must be set to serial mode
Ordering Information
Part #
VISTAHTKVR-V
iBus Wiring Limitations
Wire Gauge
Total Current of All Devices Connected to a Single Wire Run
(AWG)
50mA or less
100mA
300mA
500mA
600mA
#22
700ft (213m)
350ft (107m)
120ft (37m)
70ft (21m)
60ft (19m)
#20
1200ft (366m)
600ft (183m)
200ft (61m)
120ft (37m)
100ft (30m)
#18
1900ft (579m)
950ft (290m)
320ft (98m)
190ft (58m)
160ft (49m)
#16
3000ft (914m)
1500ft (457m)
500ft (152m)
300ft (91m)
260ft (76m)
Note:
The length of all wire runs for all partitions combined must not exceed 3000 feet (914m) when unshielded quad conductor cable is used

or 1500 feet (457m) if shielded cable is used.
VISTAHTKVR-V_DS | AR | 11/24
© 2024 Resideo Technologies, Inc.
All rights reserved
INPUT
OUTPUT
VISTAHTKVR-V
TO V-PLEX
13
14
1
2
3
4
12
11
10
9
5
6
7
8
For more information
resideo.com/pro
Resideo Technologies, Inc.
2 Corporate Center Dr. Suite 100
P.O. Box 9040 Melville, NY 11747
1-800-645-7492