Honeywell 5816OD Installation Manual
Related Products
Related Categories
Document Transcript
For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/ WARRANTY For the latest warranty information go to: http://www.security.honeywell.com/hsc/resources/wa/
General Information and Component Identification
SEALING COVER SENSOR MOUNTING PLATE
5816OD-001-V0
COMPONENT IDENTIFICATION
SENSOR
MAGNET
MAGNET SPACER
Installing / Replacing the Batteries
IMPORTANT: Energizer Ultimate LITHIUM
ADD CAULKING PRY POINTS PRY POINTS TERMINAL BLOCK FOR EXTERNAL CONTACT SWITCH
5816OD-002-V0
Mounting Guidelines
Tamper Screw Sensor Mounting Plate Mounting Surface
MOUNTING SCREW (4) SENSOR COVER SCREW FENCE
FLAT SURFACES
GATE MAGNET SPACER SENSOR MOUNTING PLATE MOUNTING SCREW (2) MAGNET
5816OD-003-V0
CURVED SURFACES
GATE POST FENCE GATE
5816OD-005-V0
COVER SCREW
SENSOR MOUNTING PLATE MAGNET
MAGNET SPACER
SENSOR
MAGNET SENSING SLIDE
5816OD-004-V0
ROUTING EXTERNAL WIRING – Optional for use with external closed contact switches, such as the Honeywell N7945-2GY:
(NC
)
(NO
ON
)
MM
OS
CO
OP
CL
EN
TO EXTERNAL CONTACT SWITCH
ED
CONNECT WIRES TO TERMINAL BLOCK IN BATTERY CHAMBER Add Caulking SENSOR
BACK VIEW
PAINTING THE SENSOR:
SEALING COVER
5816OD-006-V0
SENSOR MOUNTING PLATE
Programming the Control Panel
Final Checkout
FCC / IC STATEMENT
This device complies with Part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y compris les interferences causant une reception indésirable.
FEDERAL COMMUNICATIONS COMMISSION STATEMENT
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User’s Manual. Unauthorized changes or modifications could void the user’s authority to operate the equipment.
800-04494V1 6/11 Rev. A
2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 Copyright 2011 Honeywell International Inc. www.honeywell.com/security
- Uploaded