Qolsys IQ Tilt Quick Installation Guide

OVERVIEW
IQ TILT QUICK INSTALL GUIDE
Sensor: 2.5”H x 1”W x .5”D
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low
battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 5 years
with
3V Lithium (x2).
(2) -Panasonic CR2032
-Energizer CR2032
-Duracell DL2032
SPECIFICATIONS
The IQ Tilt is designed to tell you whether an overhead garage door is open or closed. The tilt sensor
houses a cylinder with a metal bearing inside. When the sensor is tilted, the bearing rolls down the
cylinder away from the metal contacts. This disconnects a circuit and sends a signal to the panel
saying that the garage has been opened.
NOTE: Improper orientation and/or placement of the bearing
cylinder may result in false alarms or incorrect signals.
STEP
1
REMOVE
BATTERY
TABS
STEP
2
APPLY
ADHESIVE
TUBE
ORIENTATION
STEP
3
The cylinder should be
angled inside the
sensor housing as
shown
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
STEP
3
STEP
5
LEARN
INTO
PANEL
Document#: IQTILT-QG-02-17

Revision#: 2/24/17

Issue Date: FEB 2017

Qolsys Product #: QS1121-840
STEP
4
CHOOSE
INSTALL
LOCATION
Mount the sensor horizontally with the
arrow facing DOWN, as shown.
Note: The “arrow” on the
side of the sensor should
be facing down.
SENSOR
PLACEMENT
Choose a mounting position on the top panel of the door.
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Open and close the case
to “tamper” the device
TechSupport@Qolsys.com
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-
MDWS
IC: 11817A-RF
MDWS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
CONTACT TECH SUPPOR
T
GOT QUESTIONS?