Rain Bird WIFI Controller - Install Guide

Rain+Birdt
C
Connect Zone Wires

WARNING
Electric shock can cause severe injury or death. Make sure power
supply is turned OFF before connecting power.
Controller Setup
A
Note Zone Wiring Connections on Existing
Controller

NOTE:
Check WiFi signal strength on your phone,
at the controller.
B
Mount New Controller
WiFi Controller Installation Instructions
For Outdoor Install
Power Wiring Connections
Black supply wire (hot) to the black transformer wire
White supply wire (neutral) to the white transformer wire
Green supply wire (ground) to the green transformer wire
STRAIN
RELIEF BAR
REPLACE
WIRE NUTS
Tools Needed
•
Philips head screwdriver
•
Level
•
3/8” electric drill (optional)

WARNING
Ground wire must be connected to provide electrical surge protection.
•
Remove the factory installed power cord
•
Connect external power wires using wire-nuts
•
Re-secure the metal strain relief bar
WiFi controller installation instructions (639432).indd 1
10/22/2017 9:01:51 AM
Registered trademark of Rain Bird Corporation

2017 Rain Bird Corporation P/N 639432 Rev. 10/17
A
Download Rain Bird app
B
When ready to connect, the light blinks GREEN
and RED on the LNK WiFi Module.

NOTE:
If blinking RED only, press the button on the
LNK WiFi Module.
B
Select Connected Home and turn on Alarm.com
Connected Home Setup
A
Select Settings
C
Click OK
D
Open the Rain Bird app and select Add Controller
(bottom left of screen), then follow the Setup
Wizard
WiFi Setup
D
Click Done
E
Close the Rain Bird app.
F
Complete setup via the Alarm.com Dealer
Website
C
Locate and connect to network in the phone/
tablet’s WiFi settings menu
WORKS WITH
WiFi controller installation instructions (639432).indd 2
10/22/2017 9:01:56 AM