ADI PRO 0E-SRFMTMG3W

The ADI PRO 0E-SRFMTMG3W is a 3-Wire, surface-mounted, overhead garage door sensor. The 3-wire, 36" armored cable allows for flexibility when wiring. It allows for use in a normally-open or a normally-closed loop. The 0E-SRFMTMG3W has a generous 2.5" closed gap spacing.

ADI PRO has designed their surface mount contacts with durable aluminum materials. The aluminum construction has an IP65 rating. This indicates it is dust-proof and water tight. Even the 36" cable has armored protection. They are made to withstand the abuse that a garage door contact gets exposed to. The magnet comes mounted to an L-bracket and is adjustable. This allows you to adjust the magnet spacing distance, according to your install.

The ADI PRO 0E-SRFMTMG3W is not just for garage doors. It can also be used to secure gates and other entrance points. The sensor is made where it can mount to walls and doorframes. The 0E-SRFMTMG3W has been factory tested to 50 million switching cycles to ensure its durability.

The three (3) wires on the ADI PRO 0E-SRFMTMG3W allows for versatility in connecting to your alarm or relay. This allows for it to be a single pull, double throw (SPDT) contact. What this means is it can be used in a normally-open (N.O.), or a normally-closed (N.C.) closed loop circuit. This allows it to be compatible with any hardwired zone wiring configuration. ADI PRO also has a 0E-SRFMTMG2W, a 2-wire surface-mounted contact for a N.O configuration only. ADI PRO also makes a 2-wire and 3-wire version that mounts directly to the floor next to the overhead door. The ADI PRO 0E-SRFMTOD2W is a 2-Wire overhead garage door sensor, while the ADI PRO 0E-SRFMTOD3W is a 3-Wire overhead garage door sensor. They complete their lineup with the ADI PRO 0E-TRKMTOD, which is a track-mounted overhead garage door sensor.

Have a wireless system? No worries, use a wired to wireless converter to convert your 0E-SRFMTMG3W signal into wireless. Please make sure the converter is compatible with your specific alarm system. Some will convert a single zone and some will convert multiple hardwired zones with one unit.

Specifications

• Device Type: Hardwired Door and Gate Sensor
• Installation Type: Sensor mounts to the protected side of the overhead door or gate, magnet mounts to the overhead door or gate
• Wiring: Connected 36″ (91cm) 3-wire enclosed in an armored cable
• Electrical Configuration: Normally Open/normally-closed (SPDT) open or closed loop
• Close Gap: 2.5″ (63.5mm)
• Departure Gap: 2.9″ (73.7mm)
• Contact Power Rating: 3W/200mA max (switching)
• Materials: Switch - Aluminum, Contacts - Rhodium-plated iron nickel, Magnet - Rare-earth neodymium
• Ingress Protection: IP65
• Sensor Dimensions: 3 x 1 x ½″ (76 x 25 x 13mm)
• Magnet Dimensions: 3 x 1 x ½″ (76 x 25 x 13mm), Bracket - 2¹⁴⁄16 x 2 x ¾″ (73.2 x 50.8 x 19mm)
• Operating Temperature: -15°-160°F (-25°-70°C)
• Warranty: One (1) Year