Alarm.com ADC-V820 - Install Guide

Indoor Dome (ADC-V820) - Installation Guide
Required items for installation:
•
ADC-V820 camera and power adapter (included)
•
Broadband (Cable, DSL, or Fiber-optic) Internet connection with router
•
Personal computer or web-capable tablet
•
Login/password for the customer’s Alarm.com account
•
An Ethernet cable
Install the cameras:
1.
Connect the camera’s AC adapter and plug it into a non-switched outlet.
2.
Use a standard Ethernet cable to connect the video device to the network router.
For more information about
connecting video devices using PoE, see
Connect a video device using Power-Over-Ethernet (PoE)
.
3.
Wait a few
minutes for the camera to connect to the Internet.
4.
Add the video device to the account using either MobileTech, or entering the following web
address:
www.alarm.com/addcamera
to access the Customer Website.
5.
Follow the on-screen instructions to add and set up the video device. For more information about adding a
camera
to an account, see
Enroll the video device to the customer account
.
6.
Once the camera is enrolled on the account, power down the camera and install it in its final location using the
included hardware.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor_Dome_ADC-V820/Indoor_Dome_(ADC-V820)_-_Installation_Guide
Updated: Wed, 10 Apr 2019 17:47:56 GMT
1 https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor_Dome_ADC-V820/Indoor_Dome_(ADC-V820)_-_Installation_Guide
Updated: Wed, 10 Apr 2019 17:47:56 GMT
2 LED guide
LED pattern
Status
Description
Connected to internet
Local network and internet
connection with Alarm.com IP.
Local network connection
Local network connection with local
IP address, no internet.
Note
: If the LED does not go to a
solid green after a few minutes,
see
Camera LED is blinking green
.
Power on, or no network
connection
Power on, system booting up
typically 60-90 seconds.
If solid red for longer than 60-90
seconds, then there is no
local or
Internet connection.
Firmware update
Camera firmware update is in
progress.
Factory reset
The camera is restoring to factory
default settings.
Caution
: If the camera is already
installed, it
may need to be removed
from the Alarm.com account and re-
added after a factory reset.
To perform a factory reset, press and
hold the reset button for about 10-15
seconds.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor_Dome_ADC-V820/Indoor_Dome_(ADC-V820)_-_Installation_Guide
Updated: Wed, 10 Apr 2019 17:47:56 GMT
3 Additional resources
Enroll in the
Video as a Service 201
training course today! For more information on accessing Academy
Training, see
How can I access Academy Training?
.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor_Dome_ADC-V820/Indoor_Dome_(ADC-V820)_-_Installation_Guide
Updated: Wed, 10 Apr 2019 17:47:56 GMT
4