DSC PG9914 - Mounting and Maintenance Tips

Installation Tips
PowerG Wireless Digital

Pet Immune PIR Motion Detector
PGx914
¡
¡
Installation conditions
1.
Keep away from heat sources
2.
Do not expose to air drafts
3.
Do not install outdoors
4.
Avoid installation in direct sunshine
¡
¡
Opening the detector
Using your fingers only, press on the point marked
“F” in the drawing, and separate the cover from
the base. Do not use a screwdriver.
¡
¡
Removing the pet mask
Remove the pet mask (the plastic guard) if pet immunity is not required.
1.
Place your thumb at the base of the pet mask
2.
Place your fingers at the top of the pet mask
3.
Lift the pet mask to remove
5.
Do not install near high-voltage electrical lines
6.
Do not install behind partitions
7.
Mount on a solid stable surface ¡
¡
Mounting the detector on
a bracket
1.
Align the detector with the bracket
2.
Slide the detector upward until you
hear a click
¡
¡
Disassembly from the bracket
1.
Release the screw (if a screw was used
for the installation)
2.
Separate the cover from the base
3.
Remove the battery
4.
Press on the stopper snap to release the
base from the bracket
5.
Slide the base downward to remove
www.dsc.com
2A
2B
1
3
2
¡
¡
Using brackets
(surface or corner)
Follow the instructions in the diagram
depending on what mounting method
is preferred. In corner installations, to
prevent a gap on one side from the wall,
first verify that the wall angel is 90 degrees.
1.
Surface mounting
2.
Corner mounting, use 2A or 2B
3.
For back tamper
PN 30002396