Honeywell 5802MN Installation Manual

N7131V5 5/04 Rev. A

ADEMCO 5802MN
INSTALLATION AND SETUP GUIDE

Specifications Unit Dimensions:
2.4” (61mm) x 1.5” (38mm) x 0.5” (13mm)

SUPERVISED MINIATURE TRANSMITTER

LED: Lights when unit transmits. Battery: 3V Duracell DL 2032 or Newsum, Maxell, Panasonic,
Renata, or Sanyo CR2032 In UL installations: 3V Newsum, Maxell, or Renata CR2032 only
3V LITHIUM

L

L

L

L

Back of 5802MN

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM. FCC STATEMENT FCC ID: CFS8DL5802MN CANADA: 1748101382 5 3 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. UL US Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY UL Canadian Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY ALSO LISTED FOR USE AS A SIGNAL APPLIANCE, MISCELLANEOUS CERTIFIED FOR CANADA.

5820MN

L

L

The ADEMCO 5802MN is a wireless transmitter that may be worn on a belt (belt holder supplied) or around the neck (necklace supplied). Pressing the button on the transmitter sends a signal to the control receiver. The 5802MN is intended for use only with wireless alarm systems that support 5800 Series devices. The transmitter is supervised, i.e., every hour it automatically sends a message to the control receiver that includes battery status information. This transmitter can be programmed as any zone type response (e.g., Emergency Panics, Relay Action, etc.). Battery Replacement The 5802MN is powered by a long-life Lithium battery that may be replaced when a low battery is eventually indicated by the control unit. NOTE: Although the 5802MN is water-resistant, please do not submerge. Programming the Serial Number The 5802MN has a unique identification code (serial number) permanently assigned during manufacture. You must “enroll” the transmitter’s serial number and loop number during system programming. The 5802MN may be defined as Input Type “RF” (supervised RF, for an hourly check-in; do not take out of range) or “UR” (Unsupervised RF). Its loop number is “1.” See the control unit’s Installation Instructions for further details regarding programming. When installation is complete, verify operation from desired location(s).

RENATA
CR2032

L
L

Battery Remove battery Slide cover battery under pin
L

Battery access is via a quarter turn (use a nickel to open case back). Excessive turning may result in damaging the cover. Note battery polarity: + POS end must face up (visible when installed).

L

ÊN7131V5WŠ
N7131V5 5/04 Rev. A