Honeywell 5877GDPK Programming Guide

LYNX Touch L5100 Garage Door Opener Operation with 5877GDPK
General Information The 5877GDPK includes the 5877 Relay Receiver and a SSA1 Z-WaveTM Wireless Siren & Strobe Alarm. It provides an audible and visible warning that the garage door opener is being remotely activated. If the system has been equipped for garage door control, installation of both the 5877 and SSA1 is required for remote unattended garage door control. The installation of a 5822T Tilt Sensor or Door/Window Transmitter (i.e.; 5816), allows the system to provide the status of up to three Garage Doors (one transmitter per door). The System can be armed when the garage door is open, and once the garage door has been closed, the zone will be monitored as part of the security system. It can also be programmed for monitoring only without providing burglary protection. The panel also features the option to automatically close the Garage Door(s) if it has been left open for more than a specified (programmable) period time or at a specified time.
Notes: 1. The system must be equipped with the L5100-ZWave Home Automation module. 2. The 5877GDPK is not compatible with: - Chamberlin/Lift Master MyQ technology (Including but not limited to; Models 8550, 8360 and 8500). - One piece or swinging garage doors. 3. Garage door control must have working entrapment protection (automatic reversing mechanisms and electronic photo eye sensors that detect obstructions). 4. Both the 5877 Relay Receiver and the SSA1 Siren Strobe must be installed.

Enrolling the 5877 Relay Receiver and including the SSA1 Siren/Strobe module
ACTION Note: Ensure that the 5877 Relay Receiver is in close proximity to the LYNX Touch while it is being enrolled. After the device has been enrolled it can be mounted in its permanent position but should be tested to make sure that it receives the Open/Close signals from the LYNX Touch. At the Dashboard screen select the “Automation” icon. At the second page of the Automation Screen, select the Garage door setup icon. 3. Select the Garage door to be enrolled, from the displayed list. 4. Select “Assign device”. The control advances to the Garage Door operation screen. 5. Enter the 7-digit serial number associated with the 5877 Relay Receiver then select “Done”. 6. At the 5877 Relay Receiver, depress the Program button. 7. To confirm enrollment, at the LYNX Touch select the “Learn” button and listen for a click at the relay. 8. At the Garage Door operation screen, select “Include Siren” to include the SSA1 siren/strobe module. 9. The panel displays “Entering Inclusion Mode. Please wait…” followed by “Ready to Include device. Press the function button on device”. Within one minute press the siren’s Function button. 10. If the module has been successfully enrolled, the panel displays “Device Found! Please Wait” and then the device information is displayed. Note: Repeat steps 2 through 10 to enroll up to two additional Garage Doors. 11. Select the “