Honeywell Home PROINDMV Installation Instructions - Dated 8/19 Rev. A

PROINDMV
Indoor Motion Viewer




Installation and Setup Guide

General Information

The
PROINDMV
is a battery powered, wireless indoor motion detector with a built
-in video camera designed for
use with Honeywell Home
Security Systems. The detector is pow
ered by 3
CR123A Lithium batteries that
provide
up to
4 years of battery life.

NOTE:
Installation shall be done in accordance with the National Electrical Code, NFPA 70
.
Features

•
No wiring or remote
power required. Fully portable battery powered camera all
ows for flexibility in
selecting

locations

•
Provides video
stream and live video viewing functionality

•
Spread Spectrum, Interactive, AES Encrypted Wireless technology provides optimum signal integrity and security

•
CMOS camera sensor with a wide angle
90° len
s
•
Night vision with
one white
LED

•
Fresnel lens motion detection:
39.37ft (
12m) 90° detection pattern

•
Camera sends color video


Installation Guidelines

Programming and RF testing should be done while the device is in its intended mounting location
to ensure
good communication
between the control panel and the device.


Mounting Considerations

•
Use proper tools and hardware.

•
Mount indoors in a temperature-controlled
environment.

•
Mount camera 7
.5ft (2.
3m) above the floor.

•
Do not aim detector at windows, especial
ly
those that let in direct sunlight, or at heat
sources such as fireplaces, radiators and
heating vents.

•
The detector should be installed opposed
to an access mount or asset you need to
protect.

•
Do not aim detector at moving objects
such as fans.

•
Do not p
aint or cover the detection or
camera lens.


Mounting
(Open/Close)
the PROINDMV

1. Separate the rear case/wall mount from the PROINDMV by pressing the latch
on the bottom of the case and rotating out.

2. Secure the rear case/w
all
mount in the desired loc
ation with the
two
provided screws
(See M
ounting
Options
section
below)
.

NOTE:
MUST be mounted on a stud, solid wall, or with a robust wall anchor.

3. Slide the PROINDMV
onto the
rear case/wall mount
bracket.


Mounting Options

NOTE:

Before mounting pe
rmanently,
conduct a Sensor Walk Test (see the
controller’s instructions) to verify
adequate signal strength and adjust the
device location and orientation as
necessary.


The PROINDMV can be mounted on the
wall or in corners:

•

[A]
= Wall Mounting Holes

•

[B]
= Corner Mounting Holes

•

The r
ear tamper plate MUST be
mounted to a stud, sold wood, or
with a robust wall anchor.


NOTE:
Do not aim detector at windows,
especially
those that let in direct sunlight,
or at heat
sources such as
fireplaces,
radiators and heat
ing vents.





Detection Patterns



Enrolling
the Detector

1.
Use AlarmNet 360 to program (
www.alarmnet360.com
)
2.
When prompted, insert the batteries or, if powered,
open and close again.

3.
LED flashes rapidly at power up.


After enrolling, verify adequate signal strength by conducting a sensor test (see the controller’s instructions) with the dev
ice in its
intended mounting location. Adjust the device location and orientation as necessary.

Walk Testing

After power
up and enrollment, activate the Walk Test Mode with the
controller.
Walk Test mode
is
entered/exited through “Tools” menu of the
control panel. Select the Test mode to make the PROINDMV enter Walk
Test.

NOTE:
The system must be disarmed. The system can only be armed
after exiting the Walk Test mode.


Replacing the Batteries

Use only Resideo 300-
09028, DURACELL DL123A or
PANASONIC CR
-123A, CR
-123APA/B, CR123PE/BA batteries.

BATTERY CAUTION
:
Risk of fire, explosion and burns. Do not recharge, disassembl
e,
heat above 212°
F (100°
C) or incinerate. Dispose of used
batteries properly. Keep away from children.


Specifications

Electrical

Battery
..............................................................................................................................................................................................................................
Three (3)
3V Lithium batteries

Battery Part Number
............................................................................................
Resideo 300-
09028, DURACELL DL123A; PANASONIC CR
-123A, CR
-123APA/B, CR
-123PA/BA

Nominal voltage
..........................................................................................................................................................................................................................................................
3 V

Low battery
threshold
..............................................................................................................................................................................................................................................
2.7 V

Estimated battery life
..................................................................................................................................................................................................................................
Up to 4
years

Current consumption
......................................................................................................................................................................................
Standby (1h average)
85
μA
/
Max 3
50 mA


Radio Properties

Wiselink
® technology

Radio type
..................................................................................................................................................................................................................
Spread spectrum RF bidirectional

Operati
ng frequency
..............................................................................................................................................................................................................
915 MHz (USA
& Canada)

Transmission security
.............................................................................................................................................................................................................
AES algorythm encryption

Supervision
.............................................................................................................................................................................................................................................
Radio, batteries

Radio antenna
..................................................................................................................................................................................................................................................
Integrated


Video Properties

Camera

Angle
(HFOV)
..............................................................................................................................................................................................................................................................
90°

Sensor type
...........................................................................................................................................................................................................................................................
CMOS

Spectr
al Resolution
..................................................................................................................................................................................................................................................
Color

Night
vision
.....................................................................................................................................................................................................................................
Automatic
White LED

Video
distance
....................................................................................................................................................................................................................................................
23ft
(7m
)
Video format
...........................................................................................................................................................................................................................................................
H.264

Frame rate
................................................................................................................................................................................................................................................................
10fps

Spatial r
esolution
......................................................................................................................................................................................................

QVGA (320x240) /

VGA (
640x480
)

Video File Size
.............................................................................................................................................................................................................................................
Up to 230 kB

Snapshot

Encoding
..................................................................................................................................................................................................................................................................
JPEG

Spatial resolution
.......................................................................................................................................................................................................
QVGA (320x240) / VGA (640x480)

File size
........................................................................................................................................................................................................................................................
Up to 230 kB

Streaming

Encoding
..................................................................................................................................................................................................................................................................
H.264

Spatial resolution
...................................................................................................................................................................................................................................
QVGA (320x240)

Frame rate
................................................................................................................................................................................................................................................................
10fps


Detection Properties

Infrared detection specifications

Technology
.............................................................................................................................................................................................................................................
Passive
-infrared

Type
.................................................................................................................................................................................................................................................
Dual element sensor

Lens
.......................................................................................................................................................................................................................................................................
Fresnel

Detection angle
..........................................................................................................................................................................................................................................................
90°

Detection range
...............................................................................................................................................................................................................................................
Up to 1
2m
Initialization time
............................................................................................................................................................................................................................................
90 seconds

Recovery time
......................................................................................................................................................................................................................................
90
- 180
seconds

Physical properties

Dimensions
.......................................................................................................................................................................................................

4.92 x 2.05 x 1.81 in (125 x 52 x 46mm)

Weight
...................................................................................................................................................................................................................
5.82 oz.(165g) –
includes
3 batteries

Material
...............................................................................................................................................................................................................................................................
ABS 5VB
Tamper
.........................................................................................................................................................................................................................................
Wall and cover tamper


Installation / Mounting

Mounting height
........................................................................................................................................................................................................................................
7ft. 6i
n. (
2.3m)
Application
.................................................................................................................................................................................................
Mounting on Wall
-On Flat Wall or in Corner


Environmental

Operating temperature
.......................................................................................................................................................................................................
14° to 131°F (
-10° to +55°C)

Max relative humidity
...............................................................................................................................................................................................................
93%, without condensing

Physical Protection
....................................................................................................................................................................................................................................
IP30 and IK04


Standards and Approvals

915MHz FHSS –
PROINDMV

Certifications

USA FCC Part 15C (FCC47 CFR Part 15)

CANADA IC (RSS
-247, Issue 1)


FCC ID:
.................................................................................................................................................................................................................................
CFS8DLPROINDMV

IC:
................................................................................................................................................................................................................................................
573F
-PROINDMV

HVIN:
....................................................................................................................................................................................................................................................
PROINDMV


FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA
STATEMENTS

The user shall not make any changes or modi
fications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modif
ications could void the user's
authority to operate the equipment.

FCC CLASS B STATEMENT

This equipment has been tested to FCC requ
irements and has been found acceptable for use. The FCC requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordanc
e with the manufacturer's instructions, may cause interference to radio and
television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordanc
e with the specifications in Part 15 of FCC Rules, which are designed to pr
ovide
reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, w
hich can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•
If using an indoor antenna, have a quality outdoor antenna installed.

•
Reorient the receiving
antenna until interference is reduced or eliminated.

•
Move the radio or television receiver away from the receiver/control.

•
Move the antenna leads away from any wire runs to the receiver/control.

•
Plug the receiver/control into a different outlet so t
hat it and the radio or television receiver are on different branch circuits.

•
Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA CLASS B STATEMENT

This Class B digital apparatus complies with Canadian ICES
-003.

Cet apparei
l numérique de la classe B est conforme à la norme NMB
-003 du Canada.

FCC / IC STATEMENT

This device complies with Part 15 of the FCC Rules, and Industry Canada’s license
-
exempt RSSs. Operation is subject to the following two conditions
: (1) This device may not cause harmful interference (2)
This device must accept any interference received, including interference that may cause undesired operation.



Cet appareil est conforme à la partie 15 des r
ègles de la FCC et exempt de licence RSS d’Industrie Canada
.
Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer
d’interférences
nuisibles. (2) Cet appareil doit accepter toute
interférence
reçue y compris les interférences
causant une réception
indésirable.


RF Exposure

Warni
ng
- The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from al
l persons and must not be co-
located or operating in conjunction with
any other antenna or transmitter except in accordance
with FCC and ISED multi-
transmitter product procedures
.

Mise en Garde
Exposition aux Frequences Radio:
La/les antenne(s) utilisée(s) pour cet émetteur doit/doivent
être
installée(s)
à une distance de séparation d'au moins 20 cm (7,8 pouces) de toute personne et ne pas
être située(s) ni fonctionner parallèlement à tout autre transmetteur ou antenne, excepté en conformité avec les procédures d
e produit multi transmetteur FCC et ISED
s.


Responsible Party / Issuer of Supplier’s Declaration of Conformity: Ademco
Inc., a subsidiary of Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Ph: 516-
577
-2000


SUPPORT, WARRANTY, & PATENT INFORMATION
For the latest documentation and online support information, please go to:

https://mywebtech.honeywellhome.com/


For the latest warranty information, please go to:

https://www.security.honeywellhome.com/hsc/resources/wa/index.html

For patent information, see
https://www.resideo.com/patent


MyWebTech


Warranty


Patents



The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized
recyclers. The correct disposal of end
-of-life equipment will help prevent potential negative consequences for the environment and
human health.

Device physical protection -
device shall be installed in area that is not publicly accessible

Installation physical protection -
sys
tem shall be installed in area not publicly accessible, this includes wiring protection as well

Any attempt to reverse-
engineer this device by decoding proprietary protocols, de-
compiling firmware, or any similar actions is strictly prohibited.

Ê800-
25313A*Š

800-25313A
8/19 Rev A


This product manufactured by Resideo and its affiliates.

The Honeywell Home Trademark is used under license from Honeywell International Inc.


2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747


2019 Resideo Technologies, Inc.

www.resideo.com