Honeywell LKF500 Quick Install Guide

This bi-directional wireless key fob (wireless key) is
intended for use with Honeywell controls that support
SiX™ series devices.
FC: This bi-directional wireless keyfob is intended for use
with Honeywell controls that support SiX™ series devices.
SP: This bi-directional wireless keyfob is intended for use
with Honeywell controls that support SiX™ series devices.
PA: This bi-directional wireless keyfob is intended for use
with Honeywell controls that support SiX™ series devices.
NOTE: Once enrolled in a system,
the LKF500 cannot be used with
another control panel until it is
removed from the current control
panel. See the Control’s
instructions.
FC: Note: Once enrolled in a
system, the LKF500 cannot be
used with another control panel
until it is removed from the current
control panel. See the Control’s
instructions for details.
SP: Note: Once enrolled in a
system, the LKF500 cannot be
used with another control panel
until it is removed from the current
control panel. See the Control’s
instructions for details.
PA: Note: Once enrolled in a
system, the LKF500 cannot be
used with another control panel
until it is removed from the current
control panel. See the Control’s
instructions for details.


Enroll / Enroll / Enroll / Enroll

Green LEDs Red LEDs Sounder System Status
Rapid Flash – Alternating
about 8-20 seconds, then
ON for 3 seconds
Off
chirp for
confirmation
LKF500 Enrollment
Off ON 2-3 seconds 2 beeps System Armed (any mode)
Off Slow Flash for 2-3 seconds 4 beeps
Alarm in progress or
System in Audible Panic Mode
ON 2-3 seconds Off 1 beep Disarmed, Ready to Arm
Slow Flash for 2-3 seconds Off silent Disarmed, Not Ready to Arm
Flash once (both LEDs) Off silent RF Transmission
Off Off 1 second beep Not Hearing From Panel
Rapid Flash for 2 seconds Off silent Deleting Keyfob from the system

LKF500
Buttons 1-8 / Buttons 1-8 /
Buttons 1-8 / Buttons 1-8

Press and hold the button(s)
about 2 seconds to activate.
BATTERY CAUTION: Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 212° F (100° C) or
incinerate. Dispose of used batteries promptly. Keep away
from children.
FC: BATTERY CAUTION: Risk of fire, explosion and burns. Do
not recharge, disassemble, heat above 212° F (100° C) or
incinerate. Dispose of used batteries promptly. Keep away
from children.
SP: BATTERY CAUTION: Risk of fire, explosion and burns. Do
not recharge, disassemble, heat above 212° F (100° C) or
incinerate. Dispose of used batteries promptly. Keep away
from children.
PA: BATTERY CAUTION: Risk of fire, explosion and burns. Do
not recharge, disassemble, heat above 212° F (100° C) or
incinerate. Dispose of used batteries promptly. Keep away
from children.
Product must be tested at least once each year / Le fonctionnement du produit doit être vérifié au moins une
fois par année / El producto debe ser probado al menos una vez al año / O produto deve ser testado pelo
menos uma vez por ano
Specifications:
Battery: CR2032, DL2032
RF Frequency: 2.4GHz
Operating Temperature: 32° to 122° F / 0° – 50° C
Relative Humidity: 5 – 95%, non-condensing
Dimensions: 11 mm H x 65.5 mm L x 36 mm W / 0.43” H x 2.58” L x 1.42” W
Approval Listings:
FCC / IC
ANSI/UL1023; ANSI/UL985
ULC ORD C1023; ULC S545
SIA CP-01
C-Tick RoHS
FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized
changes or modifications could void the user's authority to operate the equipment.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired
operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS-210 des Industries Canada. Son fonctionnement est soumis aux conditions
suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences
causant une reception indésirable.
RF Exposure Warning – The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
Mise en Garde Exposition aux Frequences Radio: L'antenne (s) utilisée pour cet émetteur doit être installée à une distance de séparation d'au moins 7,8
pouces (20 cm) de toutes les personnes.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS
REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
IMPORTANT! This wireless key is intended as a convenience to the user and should not be considered as a life safety device.
For the latest documentation and online support information, please go to: / Pour de l’assistance
en ligne, visitez : / Para recibir soporte en línea, visite: / Para qualquer informação adicional, contacte:
https://mywebtech.honeywell.com/
For the latest U.S. warranty information, please go to www.honeywell.com/security/hsc/resources/wa or
Please contact your local authorized Honeywell representative for product warranty information.
Pour obtenir de l'information sur la garantie de ce produit, veuillez communiquer avec le représentant
autorisé de Honeywell de votre région.
Por favor contacte con su distribuidor Honeywell Security para información sobre la garantía del producto.
Contacte o representante autorizado Honeywell local para obter informações relativas a garantia.

 2014 Honeywell International Inc. Honeywell and is a registered trademark of Honeywell International Inc.
All other trademarks are the properties of their respective owners. All rights reserved

Ê800-15960GŠ
800-15960 04/15 Rev A / BETA


2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
www.honeywell.com/security


MyWebTech

Warranty