Honeywell Total Connect Video Quicktime Setup

Technical Support Outside Step by Step Created 06/28/10

IP Video Streaming – QuickTime Setup
Follow the steps in this document to configure QuickTime if you are unable to view streaming video on the Total Connect webpage. www.TotalConnect.net
Step 1: Open up the QuickTime Player: Go to your Start Menu >Programs > QuickTime folder > QuickTime Player

1

Technical Support Outside Step by Step Created 06/28/10

Step 2: Open QuickTime Preferences: Click on Edit > Preferences > QuickTime Preferences

2

Technical Support Outside Step by Step Created 06/28/10

Step 3: Click the Advanced Tab: You will then be on the streaming setup page

3

Technical Support Outside Step by Step Created 06/28/10

Step 4: Change “Transport Setup” from Automatic to Custom:

4

Technical Support Outside Step by Step Created 06/28/10

Step 5: The Streaming Transport box will appear: “Set Transport” Protocol to HTTP and set “Port ID” to Port 80 > Click Ok

5

Technical Support Outside Step by Step Created 06/28/10

6

Technical Support Outside Step by Step Created 06/28/10

Step 6: Apply changes:

7

Technical Support Outside Step by Step Created 06/28/10

Once changes are applied you can launch the video player and stream live video. www.TotalConnect.net

Honeywell is a registered trademark of Honeywell International Inc. QuickTime® is a registered trademark of Apple Inc., registered in the U.S. and other countries. 8