Qolsys IQ Door/Window Quick Installation Guide

STEP
1
IQ DOOR/WINDOW QUICK INSTALL GUIDE
✓
Exterior Doors
✓
Sliding
glass
doors
Windows
✓
CHOOSE
INSTALLATION
LOCATION
Also great for:
Medicine cabinets
Gun safes
Garage doors
Interior doors
Sensor: 3.25”H x 1.3”W x 1”D (8x3x1.5 cm)
Magnet: 1.3”H x 0.435”W x 0.312”D (3.3 x 1.1 x 0.79 cm)

Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm (primary
open), alarm restore (primary close), external alarm
(secondary wired open), external restore (secondary wired
closed), low
battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 5 years
with
3V CR2032 Lithium (x2).
SPECIFICATIONS
SEE REVERSE FOR REMAINING STEPS
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
STEP
2
OPEN
DEVICE
CASING
Push to remove
sensor cover
STEP
3
REMOVE
BATTERY
TABS
STEP
4
CHOOSE
MOUNTING
TYPE
ADHESIVE STRIPS OR
PROVIDED HARDWARE
STEP
5
SECURE
SENSOR &
MAGNET
STEP
6
LEARN
INTO
PANEL
Document#: IQDW-QG-03-17

Revision#: 3/8/17
Issue Date: MAR 2017

Qolsys Product #: QS-1100-P01
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Open and close the case
to “tamper” the device
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2A
AJXQS1100
IC: 1
1205A-QS1100
TechSupport@Qolsys.com
CONTACT TECH SUPPOR
T
GOT QUESTIONS?
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.