Qolsys IQ Doorbell Quick Installation Guide

OVERVIEW
IQ DOORBELL QUICK INSTALL GUIDE
SPECIFICATIONS
The IQ Doorbell is a great way to make the home’s existing doorbell unit “smarter”. The IQ Doorbell
wires effortlessly into an existing door bell using the included pre-stripped leads, and
can support up
to two separate doorbells, like the front and back door. Because each doorbell learns in as two
different zones, you can program custom chimes and rules for each.
Sensor: 2.5”H x 1”W x .5”D
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low
battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 5 years
with
3V Lithium (x2).
(2) -Panasonic CR2032
-Energizer CR2032
-Duracell DL2032
IQ Doorbell
QS1119-840
WIRING DIAGRAM
RED WIRE - FRONT
BLACK WIRE - TRANS
WHITE WIRE - REAR
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
STEP
1
STEP
2
REMOVE
BATTERY
TABS
LEARN
INTO
PANEL
Document#: IQDB-QG-02-17

Revision#: 2/24/17

Issue Date: FEB 2017

Qolsys Product #: QS1119-840
WIRE THE IQ
DOORBELL
STEP
4
STEP
3
PLACING THE UNIT IN/ON
THE DOORBELL CHIME
The IQ Doorbell
leads wire to the
doorbell chime’s
TRANS, FRONT &
REAR
(optional)

terminals inside the
house. Simply wire
them inline with the
existing doorbell
button wires.
Use the supplied
double sided
adhesive tape to
mount the IQ
Doorbell on the
doorbell chime.
Make sure to put it in
an area that still
allows for the
decorative cover to
be replaced.
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Open and close the case
to “tamper” the device
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-MDWS
IC: 11817A-
RFMDWS
TechSupport@Qolsys.com
CONTACT TECH SUPPOR
T
GOT QUESTIONS?
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.