Qolsys IQ Fall Pendant - Quick Guide

CONVENIENCE ON A LANYARD
IQ FALL PENDANT QUICK INSTALL GUIDE
SPECIFICATIONS
LED Off
Standby Mode
3 Red Flashes
Powering On
1 Green Flash
Transmitting with good Battery
1 Red Flash
Transmitting with Low Battery
The IQ Fall Pendant is designed for a user to push the button for help at any time. It can also
automatically* activate an emergency alarm if it detects a fall in the event that the user is unable to
trigger an alarm by pressing the button.
Housing Dimensions: 2.32”H x 1.67”W x .75”D Oval
Button Function: Press=Activate, Release=Restore


Supervisory Signals: sent every hour.
Transmitter frequency: 319.5 MHz
Water Resistant: Rated IP45, protected from low pressure
water jets in any direction.
Battery: 3V CR2477 (x1). Typical battery life of 2 years with
an average of one activation per day.
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
* Note: fall sensors do not detect 100% of falls. If you are able to do so, you should always press the
button if you need help. Do not activate the fall sensor twice within a 10-second interval.
LED BATTERY INDICATORS: The heartbeat
LED blinks every
60 seconds.
The unit will send
a low battery
signal to notify
user.
LEARN
INTO
PANEL
Document#: IQFP-QG-12-18
Revision#: 12/3/18
Issue Date: DEC 2018
Qolsys Product #: QS1314-840
STEP
2
STEP
1
USING
YOUR
PENDANT
•
Press and hold the pendant button for .5 seconds to
activate.
•
This pendant is to be worn around the neck and
outside of clothing.
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
TechSupport@Qolsys.com
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: X08-IC319FS-1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
CONTACT TECH SUPPORT
GOT QUESTIONS?
Press and hold the button
to “activate” the device
•
It’s recommended to adjust the lanyard to rest in the
center of the breastplate.
•
Carefully place the fall sensor on a table or
nightstand when you are not using it in order to
avoid activating an alarm.
12:55 PM
07/10/17
H 70°
L 56°
SYSTEM
DISARMED