Qolsys IQ Glass-S Glassbreak Detector Quick Installation Guide

STEP
1
IQ GLASS-S
QUICK INSTALL GUIDE
CHOOSE
INSTALLATION
LOCATION
SPECIFICATIONS
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

Sensor: 2.75”H x 3.88”W x 1.5
”D
Sensing parameters: Maximum 25 feet


Mounting Spec: At least 3.3 feet from windows


being protected, and 4 feet from sources of noise
Mounting hardware: #4 or #6 screws


Replacement Battery: CR123A 1550mAH (x2)


Temperature Range: 14 ̊F to 120 ̊F

✓
Ceiling
✓
Walls
SEE REVERSE FOR REMAINING STEPS STEP
2
STEP
3
REMOVE
FACE
PLATE
STEP
4
STEP
5
REPLACE

FACE
PLATE
STEP
6
LEARN
INTO
PANEL
SECURE
TO
SURFACE
REMOVE
BATTERY
TAB
Place your panel in
“autolearn" mode
Open and close the case
to “tamper” the device
Customize name and settings
as desired and and touch “ADD”
ADD
Document#: IQGS-QG-1-17

Revision#: 1/4/17

Issue Date: JAN 2017

Qolsys Product #: QS1431-
840
TechSupport@Qolsys.com
CONTACT TECH SUPPOR
T
GOT QUESTIONS?
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-
ARGB
IC: 11817A-RF
ARGB
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.