Qolsys IQ Micro DW-S - Quick Guide



Related Products

Qolsys IQ MICRO DW-S - Encrypted Wireless Micro Door/Window Sensor
Qolsys IQ MICRO DW-S
Encrypted Wireless Micro Door/Window Sensor

Related Categories


Document Transcript

STEP
1
IQ MICRO DW S-LINE QUICK INSTALL GUIDE

Exterior Doors

Sliding
glass
doors
Windows

CHOOSE
INSTALLATION
LOCATION
Also great for:
Medicine cabinets
Gun safes
Garage doors
Interior doors
SPECIFICATIONS
SEE REVERSE FOR REMAINING STEPS
Sensor: 1.83”H x .87”W x .4”D
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low battery.
Transmitter frequency: SECURE 319.5 MHz (S-Line)
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak Strength: 69.32 dB
μ
V/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with 3V Lithium (x1).
(1) -Panasonic CR1632
-Energizer CR1632
-Duracell DL1632
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required) STEP
2
STEP
4
STEP
5
SECURE
SENSOR &
MAGNET
STEP
6
Document#: IQ-MICRO-SQG-01-19
Revision#: 1/9/19
Issue Date: JAN 2019
Qolsys Product #: QS1132-840/QS1130-840
APPLY
ADHESIVE
REMOVE
BATTERY
TABS
1”
Apply provided
adhesive strips to
the back of
sensor and
magnet.
Magnet gap
should not
exceed 1”
STEP
3
LEARN
INTO
PANEL
Customize name and settings
as desired and and touch “ADD”
ADD
Place your panel in
“autolearn" mode
Open and close the case
to “tamper” the device
Magnet locator mark
Magnet
Sensor
LINE UP
SENSOR &
MAGNET
TechSupport@Qolsys.com
CONTACT TECH SUPPORT
GOT QUESTIONS?
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2AAJXQS-IQMICRO
IC: 11205A-QSIQMICRO
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.


Uploaded