Qolsys TSB191111 - Firmware 2.4.2 - Release Notes

TSB #:
191111
DATE:
11/11/19
RE:
IQ PANEL 2 & 2 PLUS - 2.4.2 SOFTWARE UPDATE
RELEASE NOTES & UPDATE INSTRUCTIONS
Release Notes:
Fixes/Improvements
•
Fixed an issue where the new IQ Remote (QW9104-840) could continue to sound Entry Beeps for a short
period of time after disarming from the primary panel
•
PG9945, PG9312 & PG9309 sensors that are learned in remotely from Alarm.com now have a default “Sensor
Input” of Reed Switch instead of Auxiliary Normally Open
•
New setting to disable Disarm Photos on the IQ Remote
•
Added a new setting to disable the Panel Camera page from the Panel UI. When this setting is Disabled it
automatically turns off Disarm Photos, Alarm Photos, Alarm Videos & Settings Photos
•
Fixed an issue where the built-in Panel Glass Break could be defined as a Motion Detector when added
remotely from Alarm.com
•
Fixed an issue where Panel time could show an hour earlier than actual time
•
Fixed a Wi-Fi issue that occurred when remotely requesting the Panel to scan for Wi-Fi networks from
Alarm.com
•
Added the ability to get consecutive Doorbell chime tones when the Skybell is pressed multiple times during a
single notification event
•
When pushing a Panel software update from Alarm.com, the randomized delay of 0 to 30 minutes has been
reduced to 0 to 5 minutes in order to speed up the update process (will apply when updating from 2.4.2 to a
higher version)
•
Fixed an issue that was introduced in 2.4.1 where the Thermostat page on the Panel could be blank
Update Instructions:
Compatibility Note: Your IQ Panel must be on software version 2.0.1 or higher and connected to Wi-Fi to install
this update wirelessly.
1- Swipe down from the top of the screen and touch “Settings"
2- Touch “Advanced Settings”


3- Enter a valid installer code (default is 1111)


4- Touch "Upgrade Software"
5 -Touch “Patch Tag” and enter the patch
iqpanel2.4.2
then touch OK


6- Touch "Upgrade Using Network" (panel must be connected to Wi-Fi).
 
Update will download and install


7- Once complete touch "OK" to reboot the panel.
 
DO NOT TOUCH THE SCREEN.

 
The update process will
take approximately 5 minutes. After the panel reboots the home screen will appear and the LED will turn green.
For more information visit:
https://login.qolsys.com/software-downloads/
or email:
techsupport@qolsys.com
TECHNICAL SERVICE BULLETIN
IQ PANEL 2 & 2 PLUS - 2.4.2 SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS