Telguard HomeControl Flex with Concord Express - Install Guide

Rev 2
.0


1


© 2015 Telguard

HomeControl Flex

Installation: TG
-
1 Express with
GE Concord Express

The
following information is to serve as a guide for installations of TG
-
1Express devices enabled for
Interactive Services with the
GE Concord Express
. The configuration shown in the diagram below is an
example of how a proper installation could look.
Although the

zone could differ from the diagram without
changing the outcome of the installation
, the output to be used must be
OUT2
.

Installation Diagr
am

STC
STC
TRIP IN
GND
DC
+
1
:
Ring return
2
:
GND
3
:
STC
4
:
Ring
5
:
Tip
6
:
STC
7
:
DC
+
8
:
Tip return

Note:

Although a resistor is not depicted here, one may be required by the Keyswitch zone in accordance to the
Panel’s specifications. For more information, please refer to the Panel’s Installation and/or Programming Manuals.

Rev 2
.0


2


© 2015 Telguard

Programming Steps

After getting i
nto configuration mode, check/do the following:

Program Keyswitch

zone
:

Enable Open/Close Reports:




Rev 2
.0


3


© 2015 Telguard

Program Output:

Set
to
Contact ID:

Reference Note

For more detailed TG
-
1B and TG
-
4 installation and programming instructions,
refer to the
HomeControl Flex Installation Guide.