Alarm.com NX-410-US-VZ-LTEUP
Verizon LTE Upgrade for Interlogix NX Panels (NX Gateway Not Included)
Description
The NX-410-US-VZ-LTEUP is a Verizon LTE upgrade module for Interlogix NetworX NX4V2, NX6V2, NX8V2, and NX8E panels. Because it does not include the NX Gateway module (NX592E), the interface required to translate between the LTE communicator and the NetworX panel bus, it should only be used to upgrade from an older cellular communicator to the Verizon LTE one.
It is assumed that anyone who uses this LTE upgrade communicator will be replacing an older, obsolete CDMA or GSM one in an existing NetworX panel. In this scenario, the NX Gateway module should already be in place. The user will simply power the system completely down, remove the CDMA or GSM module, replace it with this Verizon LTE upgrade module, and then power everything back up.
In order to successfully install and register the NX-410-US-VZ-LTEUP, Alarm.com recommends that you create the Alarm.com account for the device at least 24 hours prior to physically installing it. Once power has been applied to the unit, check the signal strength LEDs to find the perfect installation location, and then perform a phone test to register the device.
The NX-410-US-VZ-LTEUP module receives its power from the Interlogix panel, so no separate wiring for power is required. Once installed and registered, the user will have access to the Alarm.com suite of remote automation and system control. With its built-in Z-Wave controller, both manual control and automation can be achieved for Z-Wave lights, locks, thermostats, and other devices. In addition, all of the other Alarm.com third-party automation options such as Sonos, Rainbird, MyQ, and others will also be available.
Specifications:
- Compatibility: NX 4 (v2), NX 6 (v2), NX 8 (v2), and NX 8E (v2)
- Carrier: Verizon LTE
- Power Requirements: 9.5 to 15 VDC, 12 V nominal, 65 mA (continuous) 1600 mA (instantaneous peaks) maximum
- Operating Temperature: 32 to 120°F (0 to 49°C)
- Storage Temperature: -30 to 140°F (-34 to 60°C)
- Operating Humidity: 90% non-condensing
- Dimensions (H x W x D): 5.25" x 4.125" x 1.0" (13.335 cm x 10.477cm x 2.54cm)
Brand: Alarm.com