ADC-VC736 Indoor/Outdoor Bullet Cam Install Guide



Related Products

Alarm.com ADC-VC736 - Outdoor 1080P POE Large Bullet Camera with Night Vision
Alarm.com ADC-VC736
Outdoor 1080P POE Large Bullet Camera with Night Vision
List Price: $280.00
Our Price: $196.99

Related Categories


Document Transcript

Indoor/Outdoor Bullet Camera (ADC-VC736) Installation Guide
Pre-Setup Checklist

ADC-VC736 camera (included)

AC power adapter (required for non-PoE connections)

Broadband (Cable, DSL or Fiber Optic) Internet connection with router

A computer or mobile device with Internet access

An Ethernet / Cat5 cable

Login and Password for the Alarm.com account to which you will add the camera
Add the Camera to an Alarm.com Account
Complete these steps prior to installing the camera in its final location:
1.
Connect the camera to the router via an Ethernet cable.
2.
If the Ethernet connection does not provide power, connect the camera to the optional AC power adapter (sold
separately) and plug the adapter into a non-switched outlet.
3.
Wait 2 minutes for the camera to connect to the Internet.
4.
Add the device by either selecting the account in MobileTech or by using a web browser and entering the following
URL:
www.alarm.com/addcamera
5.
Select the camera from the video list or type in its MAC address to begin adding the camera. The camera’s MAC
address is located on the product label.
6.
Follow the on-screen instructions to finish adding the camera. You may configure camera settings from the
Customer Website.
You can now unplug the camera and install it in its final location using the included hardware.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)_Installation_Guide
Updated: Fri, 31 Aug 2018 17:10:05 GMT
1 Troubleshooting
If you have issues connecting the camera to the account, power cycle the camera and try again.
If issues persist, reset the camera to factory defaults by following these steps:

Disconnect the camera from the power supply.

Use a Phillips-head screwdriver to remove the water-tight door on the bottom of the camera and locate the Reset
button.

Press and hold the Reset button while reconnecting power. Continue to hold the Reset button for 10 seconds.
Questions?
Visit the
Alarm.com Support Center
.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)_Installation_Guide
Updated: Fri, 31 Aug 2018 17:10:05 GMT
2


Uploaded