Alarm.com ADC-VC826 - Installation Guide

Indoor/Outdoor Dome (ADC-VC826) - Installation Guide
Pre-setup checklist
•
ADC-VC826 camera (included)
•
AC power adapter (required for non-PoE connections)
•
Broadband (Cable, DSL or Fiber Optic Internet connection with router)
•
A computer or mobile device with Internet access
•
An Ethernet / Cat5 cable
•
Login and Password for the Alarm.com account to which you will add the camera
Add the camera to an Alarm.com account:
Complete these steps prior to installing the camera in its final location:
1.
Connect the camera to the router via an Ethernet cable.
2.
If the Ethernet connection does not provide power, connect the camera to the optional AC power adapter (sold
separately) and plug the adapter into a non-switched outlet.
3.
Wait two minutes for the camera to connect to the Internet.
4.
Add the device by either selecting the account in MobileTech OR by using a web browser and entering the
following URL:
www.alarm.com/addcamera
Note
:
For
information about how to install
a video device via MobileTech, see
Install a video device using the
MobileTech app
.
5.
Select the camera from the video list or type in its MAC address to begin adding the camera. The camera’s MAC
address is located on the base of the camera.
6.
Follow the on-screen instructions to finish adding the camera. You may configure camera settings from the
Customer Website.
You can now unplug the camera and install it in its final location using the included hardware.
For information about how to reconnect a camera to a network, see
Reconnect a camera to a Wi-Fi network if the router,
network equipment, or wireless settings change
.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)_-_Installation_Guide
Updated: Wed, 15 Aug 2018 14:52:35 GMT
1 Troubleshooting
If you have issues connecting the camera to the account, power cycle the camera and try again.
If issues persist, reset the camera to factory defaults by using the Reset button located under the camera cover.
•
Disconnect the camera from the power supply.
•
Unscrew and remove the camera cover, being careful not to damage the connecting wires.
•
Press and hold the Reset button while reconnecting power Continue to hold the Reset button for 10 seconds.
Questions?
Visit:
www.alarm.com/supportcenter
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)_-_Installation_Guide
Updated: Wed, 15 Aug 2018 14:52:35 GMT
2