Honeywell LNYXGSMEXTCB - Install Guide

Document ID: 800-07760 10/10 REv B

Connecting LYNX Series Controls
to the
GSMX4G
, GSMV4G
,
IGSMV4G, or CDMA
-X Communications Device

For Online Support visit:
https://mywebtech.honeywell.com


Refer to
the
GSMX4G
, GSMV4G, iGSMV4G or CDMA
-X and LYNX PLUS, LYNXR
-2 or LYNXR
-I Installation
Instructions for additional information and procedures. If you are installing the Communications Device with a
LYNX PLUS control, ensure that the
LYNXGSMEXTCB Cable Assem
bly

is properly routed. If used,
interconnecting wiring between the cable and the communications device must not exceed 20ft in length.

Connecting
the
GSMX4G
or CDMA
-X
1.
Splice the stripped end of two LYNXGSMEXTCB Cable Assemblies
(P/N 600-
00151) to each ot
her as shown in Figure 1
and Table 1.


It is essential that the wires are spliced exactly as shown on Figure 1. If used, interconnecting wiring between
the two LYNXGSMEXTCB Cable Assemblies

must not exceed 20ft in length.

2.
Connect one end of the spliced LYNXGSMEXTCB Cable Assembly
(P/N 600
-00151) to the receptacle on
GSMX4G or
CDMA
-X
as shown in Figure 1.

3.
Connect the other end of the spliced LYNXGSMEXTCB Cable Assembly
(P/N 600-00151) to the communications port
on the LYNX PLUS, LYNXR
-I or LYNXR
-2 as show
n in Figure 1. For the LYNX PLUS, ensure that the cable is properly
routed as shown on Figure 2.

Table 1.
Cable
Assembly LYNXGSMEXTCB Splice Configuration

LYNX Series

GSMX4G or CDMA
-
X

Yellow

Green

Red

Black

Black

Red

Green

Yellow



Figure 1.
GSMX4G

or CDMA
-
X

Connections


Figure
2. LYNX PLUS Cable Routing

Connecting
the
GSMV4G


Power for the
GSMX4G
, GSMV4G, iGSMV4G or CDMA
-
X

is provided by the LYNX Series Control. D
o not install
the battery in the control
. Connecting the battery will significantly
decrease the backup battery life of the LYNX
Series controls.

1.
Connect the connector of the
LYNXGSMEXTCB C
able
Assembly
(P/N 600
-00151) to the communications port on the
LYNX PLUS, LYNXR
-I or LYNXR
-2 as in Figure 3. For the LYNX PLUS ensure that the cable is properly routed as
shown on Figure 2.

2.
Connect the four stripped wires from the LYNXGSMEXTCB Cable Assembly
(P/N 600
-00151) to the
GSMV4G
or
iGSMV4G
as shown in Figure 3.

3.
Connect a jumper wire between Terminal 2 and 3 on the

GSMX4G, GSMV4G, iGSMV4G or CDMA
-X

as shown in
Figure 3.


Figure
3. GSMV4G or
iGSMV4G

Connections

Ê800 -07760@Š

800
-
07760 10/10 Rev. B