Qolsys IQ Door Window-S QS 1133-840 Quick Guide

STEP
1
IQ DOOR/WINDOW
S-LINE QUICK INSTALL GUIDE
✓
Exterior Doors
✓
Sliding
glass
doors
Windows
✓
CHOOSE
INSTALLATION
LOCATION
SPECIFICATIONS
SEE REVERSE FOR REMAINING STEPS
Sensor: 2.6”H x .75”W x .7
5”D
Code outputs: tamper, tamper restore, alarm, alarm
restore, low
battery.
Transmitter frequency: SECURE 319.5 MHz (S-Line)
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 7 years
with 3V CR2 (x1
).
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

Note: Battery Safety
Observe polarity when inserting replacement batteries to avoid damaging
the sensor.
Risk of fire, burns and explosion. Do not recharge, disassemble, burn or
expose batteries to temperatures above 100C (212F).
Dispose of used batteries properly and in accordance with all local laws
Keep batteries away from children. STEP
2
STEP
4
STEP
5
SECURE
SENSOR &
MAGNET
STEP
6
Document#: IQDW-SQG-06-17

Revision#
: 6/2/17
Issue Date: JUN 2017

Qolsys Product #: QS1133-840

APPLY
ADHESIVE
REMOVE
BATTERY
TAB
Apply provided
adhesive strips to
the back of
sensor and
magnet.
Magnet gap
should not
exceed 1/2
”
STEP
3
LEARN
INTO
PANEL
Place your panel in
“auto learn" mode
Customize name and settings
as desired and touch “ADD”
ADD
Open and close the case
to “tamper” the device
Magnet locator mark
s. Magnet
can be placed on either side of
sensor.
Magnet
Sensor
LINE UP
SENSOR &
MAGNET
TechSupport@Qolsys.com
CONTACT TECH SUPPOR
T
GOT QUESTIONS?
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-
MDWS-HP-S
IC: 11817A-RF
MDWSHPS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.