Resideo Lyric to PRO Series Replacement Steps - Dated 01/20/21

1
1/20/2021

Replacing a Lyric
Panel with a Pro Series Panel
To replace a Lyric
panel with a PRO Series panel, follow these steps...


Note! The Pro Series Panel must remain powered down until Step 8.


1.

The programming of the Lyric
Panel can't be transferred to a Pro panel, so make note of
any programming you would like to save such as User Codes. Also
, if 5800 series
wireless is being used on the Lyric panel you can write down the Serial number and
Loop
number of each transmitter to program into the Pro Series panel if desired.
Any
Total Connect configuration will also need to be recreated, so be sure to note any
enabled cameras, devices or integrations that will need to be reconfigured.
2.

Contact the Central Station to Partially Cancel the Lyric Account
. If reusing the same
account, wait for at least 30 minutes before setting up the PRO panel in AlarmNet 360.
3.

At the Lyric Panel. Confirm that all the SiX devices are powered up and within range of
the panel to receive the unpair command.

4.

Locally default the Lyric control panel. This will send the 'unpair' to all the SiX series
transmitters. If there are any SiXFOB's
press any key on the fob to confirm the release.

5.

Power down the Lyric panel.

6.

Create the Pro Series panel Account as a New account on the AN360
website
or AN360
Mobile App
.
7.

At this time, if desired you can also edit the Pro Panel programming, adding the u
ser
codes and 5800 transmitter information, and any other programming except the SiX
transmitter zones, which must be learned in a later step.

8.

Once the AN360 steps are complete, Power up the Pro
panel, join the Wi
-Fi network
when prompted, or wait until Ce
ll Module is initialized and press NEXT on the screen.

9.

Press 'Register' on the screen when prompted. Allow the Pro
panel to Register and
Associate and pull down the Account
Programming.

10.

Once completed the Panel will display the Home Screen.

11.

Each SiX Trans
mitter and SiXFOB can now be Learned into the Pro Panel using AN360
Sensor Programming.

12.

Any Lyric LKP500 keypads will need to be replaced with PRO series keypads.

13.

Once all the SiX sensors are enrolled, from
AN360
'Updat
e Device Firmware' to updat
e
all
SiX devices to PROSIX version. Test all Sensors in the Sensor Test mode and
confirm
function of all Keypads
and
Keyfobs. Sirens especially must be updated before they will
sound.

14.

Eac
h Z
-Wave Device will need to be Excluded
and
Included
into the Pro
Panel.

15.

Reconfigure the Total Connect account.