Can I Use an L7000 As A ZWAVE Controller w/o Monitoring

Yes, the Honeywell Lynx Touch L7000 comes equipped with zwave automation capability. The Lynx Touch L7000 is compatible with the L5100-zwave module. The L5100-zwave module is a zwave controller made especially for the Lynx panel series. The L5100-zwave module is a separate piece of equipment and sold separately.

To install the L5100-zwave module, start by separating the Lynx L7000 case from the front and back by depressing the 2 (two) tabs on the top of the case using a small screwdriver. Install the L5100 zwave module, component side up, making sure the modules receptacle is securely seated on the panel’s edge connector. The panel’s edge connector will be found towards the bottom left hand side. Make sure you install the zwave module on the botton left - the bottom right has a similar connector but is for wifi connection. Close the Lynx L7000 case by snapping it back together.

Once the L5100-zwave module is installed, zwave devices can be enrolled and users can control, lights, thermostats, door locks, and more.

The Lynx Touch L7000 supports up to 40 (forty) zwave light modules, 4 (four) zwave thermostats and 6 (six) zwave door locks.