How Do I Put the 2GIG GC2 Into Learn Mode?

You can put the 2GIG GC2 into learn mode through the system configuration menu. First choose the zone number you want to use with the sensor. Then scroll down to the serial number option. Then click the "shift" button. Finally, click on the "learn" button to put the panel into learn mode.

Learn mode allows you to auto-enroll sensors with the GC2 Panel. If you activate a sensor while the system is in this mode, it will automatically be detected. It can then be configured for use with the GC2 System.

Complete the following steps to put the 2GIG GC2 into learn mode:

1. Enter programming. From the home screen of the GC2, click on the Go Control icon in the lower-right corner of the screen. Then enter the Installer Code. The default Installer Code is 1561. Choose the option "System Configuration". This will take you to the programming menu for the GC2.

2. Choose a sensor number. The main screen of the system configuration menu allows you to select which sensor number you will be working with. Use the left and right arrows to scroll until you reach the sensor number you want to use. Alternatively, you can also enter in the 2-digit sensor number on the keypad. Proceed to the next step once you have reached the desired sensor number.

3. Access serial number settings. Pressing the down arrow will take you to the next set of options for that wireless zone. Press the down arrow three times from the sensor number selection. This will take you to an option for serial number. This is also where you can manually enter in the serial number for a sensor. The learn mode for the GC2 system is found within this setting option.

4. Enter learn mode. While at the serial number selection screen, press the "shift" button at the bottom of the screen. Then press the "learn" button on the left side of the screen. The message "Activate a sensor to learn its ID" will be displayed at the top of the screen. This will indicate that you have successfully entered learn mode.