Qolsys IQP4STAND

The Qolsys IQP4STAND comes in two (2) color options, Black or White. It uses the new Qolsys SmartMount system for easy installation. A table stand is perfect for times when you want to install the system, but you don't want to make holes in the walls. This could be because you're in an apartment, or because you're staying in a temporary location and plan to move soon. The Qolsys IQP4STAND-BLK matches the IQ Panel 4 in Black and the Qolsys IQP4STAND-WHT matches the IQ Panel 4 in White. Be sure to choose the correct option to match your panel.

To install, loosen the locking screw from the bottom rear of the panel using a small Phillips head screwdriver. Remove the SmartMount backplate and either store or discard it. Plug in the barrel connector end of the included power supply at the panel. Make sure it seats fully and that the battery is also plugged in. The power supply should not be plugged in at this time.

Route the power wire out through the middle of the SmartMount table stand. Insert the hooks at the top of the table stand into the corresponding slots on the top back of the panel. Swing the stand down and lock it into place. Finally, using the Phillips head screwdriver, tighten the locking screw on the bottom rear of the panel to lock the table stand in place. Plug in the power supply and power on the system using the power button on the right side of the panel when you're ready.

Important Note: The IQ4 Hub versions that support Dual SRF have a pigtail antenna that comes out the back of the panel. When wall mounting, this antenna can simply be stuck into the wall. However, when desk mounting, this antenna should be threaded through a small knockout that is in the back of the IQP4 Stand. Earlier versions of the stand didn't have this knockout, as this change was added in later production runs.