Wired to Wireless Security System Transmitters Frequently Asked Questions
Can I Convert a Wired Alarm Into a Wireless Alarm?
It is possible to connect wired sensors to a wired to wireless converter so that they can be used with a compatible wireless system. Learn about wired to wireless converters.
Can I Add Additional Zones to My Qolsys IQ Hardwire 16-F After Initial Setup?
All zones on the Qolsys IQ Hardwire 16-F use end-of-line resistors. A new sensor can be wired with the resistor and then learned into the panel. Learn about the IQ Hardwire 16-F.
Will The Lyric Controller Work With Wired Honeywell Sensors?
The only way to make a Lyric Controller support wired sensors is to use a wired to wireless converter. A good device for this is the Honeywell 5800C2W. Learn about wired sensors.
How Do I Incorporate a Wired Contact Sensor with a Wireless Alarm System?
There are a few different ways that a wired alarm contact can be used with a wireless system. The most common way is to use a converter. Learn about wired alarm contacts.
Will Honeywell 5800 Sensors Work on an Interlogix Simon XT?
The Simon XT communicates with wireless sensors that operate at a frequency of 319.5 MHz. Since Honeywell 5800 Sensors operate at a frequency of 345 MHz, they cannot be used with the system. But there are many other sensors that will work instead. Find out which sensors will work with a Simon XT.
How Do I Add a 4-Wire Smoke Detector to My Wireless Alarm System?
In order to use a 4-wire smoke detector with a wireless alarm system, a special type of wireless transmitter is needed. The transmitter must be capable of supporting normally open life-safety devices with an end of line resistor. Learn more about using a 4-wire smoke with a wireless system.
It is possible to connect wired sensors to a wired to wireless converter so that they can be used with a compatible wireless system. Learn about wired to wireless converters.
Added:
Can I Add Additional Zones to My Qolsys IQ Hardwire 16-F After Initial Setup?
All zones on the Qolsys IQ Hardwire 16-F use end-of-line resistors. A new sensor can be wired with the resistor and then learned into the panel. Learn about the IQ Hardwire 16-F.
Added:
Will The Lyric Controller Work With Wired Honeywell Sensors?
The only way to make a Lyric Controller support wired sensors is to use a wired to wireless converter. A good device for this is the Honeywell 5800C2W. Learn about wired sensors.
Added:
How Do I Incorporate a Wired Contact Sensor with a Wireless Alarm System?
There are a few different ways that a wired alarm contact can be used with a wireless system. The most common way is to use a converter. Learn about wired alarm contacts.
Added:
Will Honeywell 5800 Sensors Work on an Interlogix Simon XT?
The Simon XT communicates with wireless sensors that operate at a frequency of 319.5 MHz. Since Honeywell 5800 Sensors operate at a frequency of 345 MHz, they cannot be used with the system. But there are many other sensors that will work instead. Find out which sensors will work with a Simon XT.
Added:
How Do I Add a 4-Wire Smoke Detector to My Wireless Alarm System?
In order to use a 4-wire smoke detector with a wireless alarm system, a special type of wireless transmitter is needed. The transmitter must be capable of supporting normally open life-safety devices with an end of line resistor. Learn more about using a 4-wire smoke with a wireless system.
Added: