Complete Guide to Installing & Programming an L5200 Kit

The idea of installing a whole security system all by yourself might seem daunting. Trust us when we say it's not. The Honeywell L5200 security systems are both high quality, and incredibly simple for end-users to install. We've put this nuts to bolts blog post together using our YouTube channel to give you the resources to do everything you need to make sure your system is in order.

Installing the L5200

Making sure that the L5200 is properly installed is the key to a successful installation. If you want to mount it on your wall, follow the instructions on our L7000 installation video (which uses wire track) or our L5100 installation video (wherein Sterling fishes the LT-cable through the wall). Whether you're putting the L5200 on a flat surface using the L5000DM, or mounting it on the wall, the installation is straightforward.

Installing the Communicator(s)

The communicators are simple to put into the system. For those with an iLP5 who did not buy one of our pre-made kits, the installation is simple as well. For the rest of you, the kits come with either the L5100-WIFI, the 3GL, or both. In the following video, Sterling installs the L5100-WIFI into the L5200 security system. As you can see, opening up the system, and mounting it to the board on the right side couldn't be easier.

The 3GL (which at the time of our filming was called GSMVLP5-4G) is about as quick. While Honeywell recommends that it be affixed with screws, the installation should take you no more than a few minutes.

Programming the Sensors

Our kits, for the most part, come with Honeywell's wireless 5811 sensor. Below is a video on programming the 5811 sensor to the L5200 security system.

We do have kits with the 5816s. If you have purchased a kit including some 5816s, the difference in programming is significant enough that it's worth watching the 5816 programming video. The most common issue that end users run into when programming a 5816 is setting it to loop 1 as is commonly done with every other sensor. In the case of the 5816, loop 1 is reserved for when the 5816 is being used as a wired to wireless transmitter. Loop 2, on the other hand, is what one uses when using the 5816 as a traditional wireless security sensor.

The 5800PIR-RES motion detector is the motion sensor that comes with the kits. An excellent motion with pet immunity, the sensor is simple to program and install. In the video below, Sterling explains how to install program the sensor to the L5200.

Finally, the security system comes with a Honeywell 5834-4, 4-button key fob. Programming the key fob is quite like programming all the other sensors, though it is programmed in a section different from the other sensors as you can see in the following video.

Installing the Sensors

The sensors are simple to install. The 5811s can be installed on a door or window with the right amount of lip. In the following video, Sterling installs the 5811s on a double french door.

Motion sensors are a little bit more tricky. While the sensor is programmed, a installation requires 1) a walk-test to ensure that it is installed in a location that will adequately protect a room, in addition to 2) drilling it into a location on the wall. Below we demonstrate the walk-test that should be performed before installation.

Once a walk-test confirms the mounting location is correct, you can install the 5800PIR-RES in a corner mount location.

Following these instructions will help you complete the installation of your L5200 security system.

If you find these videos helpful, we'd love for you to subscribe to our youtube channel.