Qolsys IQ Panel 2 and 2 Plus - Firmware Update Required

Qolsys IQ Panel 2 equipment that uses an AT&T LTE Cellular Communicator requires a firmware update prior to the AT&T 3G sunset date of 02/22/22. Without this update, these devices will lose their connection to the cellular network. The update can be performed over WIFI, or by using an SD Card

If a WIFI signal is available in the location where the Qolsys IQ Panel 2 is installed, but the panel is not currently connected to it, there are a few different ways to connect:

1. Locally: The connection can be made at the panel using the touchscreen. Instructions for connecting to WIFI locally can be found here.
2. By dealer remotely: Alarm.com dealers, like Alarm Grid, can use the Partner Portal to connect the panel to WIFI. This is found on the Partner Portal website under the Signaling/Broadband Settings.
3. By user remotely: Starting on 12/13/21, Alarm.com is enabling a tool that allows an end-user to connect the panel to WIFI through the Customer Alarm.com App or Alarm.com Website.

In order for the customer to connect their panel to WIFI using the customer app they will click on: Menu > Manage Devices > Select the 3-dots icon next to the panel's name > Select Device Settings > Select Panel WIFI. From there the user can either choose an existing camera to copy that device's WIFI settings, or select the SSID and complete the authentication process. Once the connection to WIFI is made, the communication path will be changed from Cell-only to Dual-Path. This may be useful for panels installed in locations where the building is not always occupied.

Starting on Monday, January 10, 2022 Alarm.com will begin to automatically deploy the firmware update to any WIFI connected panel that has not already received it. The automatic update process will proceed through the queue of needy panels 7 days per week during daytime hours (8am - 8pm panel time). As part of the update, a system reboot will occur.

In some cases, the panel's firmware may require an update before the cellular firmware update can be implemented. Panels that are on version 2.3.0 or lower must update to a minimum of 2.3.1 or higher. Panel firmware updates on panels that have a WIFI connection can also be performed locally from the panel with a Patch Tag, or can be done remotely via Alarm.com's Partner Portal. Once the panel's firmware is on a compatible version (see the link in the paragraph below) the cellular firmware can be installed using the patch tag: ATT3GSunset

For panels that have no WIFI connection available, the Qolsys IQ Panel 2 can be updated locally using a Micro SD Card. The upgrade files, as well as instructions on how to perform the local upgrade are available on Alarm Grid's Qolsys IQ Panel 2 Plus Firmware Update page. Eventually, Qolsys will also make the cellular firmware update patch available for download and install via Micro SD. Once they do, we will also host it on our site. As of 12/10/21, it is not yet available.

This issue only affects AT&T LTE Cellular units. Verizon units are not affected. This issue is occurring because early Qolsys AT&T units used a provisional VoLTE Firmware Version. This later changed when VoLTE was fully released. Since the difference between the provisional firmware and the released version didn't affect a panel's ability to communicate via cellular, no action was required before. If you are unsure whether your panel requires the update or not, contact your alarm dealer. They will be able to verify this information for you, as this information is only available when checked through the Partner Portal Website, and is not available from the Alarm.com Customer App or Website. Read the full Qolsys Technical Service Bulletin here.