Alarm Grid Video Recap: April 5th

It's always a great start to the week when there's a new Alarm Grid video recap! We have six (6) new videos to check out this time. I had to step in front of the camera again, as others continue to work from home. It will be a bit longer before others return. But anyway, here are the videos.

Interlogix Simon XTi & XTi-5: Setting Installer Code to Default

I show you how to set the Installer Code on an Interlogix Simon XTi or Interlogix Simon XTi-5 to its default setting. The default Installer Code for these systems is 4321. This is actually the same default code as the default Dealer Code for these systems. The only way to have the same Installer Code and Dealer Code on an Interlogix Simon XTi or Interlogix Simon XTi-5 is to keep both of the codes at their default setting of 4321. If you change either code, then you must factory default the system to get both codes back to the default.

IQ Panel 2 Plus: Setting Installer Code to Default

I show you how to set the Installer Code on a Qolsys IQ Panel 2 Plus back to default. This system has a default Installer Code of 1111. Alarm Grid recommends keeping the code at its default so that you do not become locked out of programming. If you forget the default code, you can always look it up later. Keeping the Installer Code at the default does not present a security risk because you cannot disarm the system with that code. To reset the Installer Code, you must know either the current Installer Code or the current Dealer Code.

Connecting August Smart Lock Pro to WIFI

I show you how to connect the August Smart Lock Pro to a WIFI network. To do this, you will need an August Connect WIFI Bridge. Alarm Grid sells a bundled kit that comes with both devices. Connecting your August Smart Lock Pro to WIFI will allow you to control the lock remotely through the August Home App when your phone is outside of Bluetooth range. The only other ways to control the lock remotely are outside of the August App through Apple HomeKit or Z-Wave. The August App switches to WIFI automatically once you are outside of Bluetooth range.

Using August Smart Lock Pro With Apple HomeKit

I show you how to configure the August Smart Lock Pro for use with Apple HomeKit on an Apple iOS device. All HomeKit communication for the August Smart Lock Pro occurs through wireless Bluetooth connectivity between the lock itself and a dedicated HomeKit Hub. The dedicated HomeKit Hub can be an Apple iPad, an Apple HomePod, or an AppleTV Gen 4 or higher. You must keep the dedicated HomeKit Hub within Bluetooth range at all times for proper connectivity. The lock cannot use WIFI to communicate with the HomeKit Hub, even if an August Connect WIFI Bridge has been configured.

Wired Alarm System: Power Cycling

I show you how to power cycle your hardwired security system. Power cycling, or a power cycle reset, involves powering the system down and then powering it back on. There are a few reasons you might do this. If you are adding new hardware, such as a new keypad or a new alarm monitoring communicator, then you must power down your system first, and then power it back on after the hardware is installed. You might also power cycle as a general troubleshooting step. Most wired alarm panels require you to manually remove and restore power to fully power cycle.

Wireless Alarm System: Power Cycling

I show you how to power cycle your wireless security system. The reasons for power cycling a wireless system are usually the same reasons you would power cycle reset a wired alarm system. These reasons include making hardware changes and general troubleshooting. But for a wireless system, there is often a menu option you can use to reboot the system, without needing to manually drop and restore AC power and battery power. You should refer to the installation manual for your wireless alarm system to learn how to reboot through a menu selection, as it differs between systems.