IQ Panel 2 Plus - PowerG Radio Firmware Update

Hi DIYers! We have learned that there is a radio firmware update for the PowerG Daughtercard used with the Qolsys IQ Panel 2 Plus Systems. The new radio firmware is v80.25, and it provides various fixes for sensor compatibilities. The update can be applied by entering a patch tag.

The new radio firmware for the Qolsys IQ Panel 2 Plus PowerG Daughtercard provides some general fixes for using the system with PowerG Sensors. According to Qolsys, radio firmware version 80.25 fixes a transmission delay that occurs when PowerG Sensors are enrolled on IQ Panel 2 Plus Zones 1, 2, and 3. It also corrects the PowerG compatibility issues that many users experienced when trying to use the PowerG PG9914 Wireless Motion Sensor and the PowerG PG9933 Wireless Carbon Monoxide Sensor on radio firmware version 80.17.

There are two ways for Alarm Grid monitored customers to apply this firmware update. The first is to contact us to have the firmware update pushed down automatically from Alarm.com. This will require a small added fee, which will be applied to the customer's next bill. If you want to update the radio firmware for free, you can perform it manually by completing the following steps:

1. Click the small grey bat at the top of the main screen.
2. Press Settings.
3. Press Advanced Settings.
4. Enter Installer Code (default 1111).
5. Press Upgrade Software.
6. Press Patch Tag.
7. Enter v3cardfix1 and press OK.
8. Press Upgrade Using Network.

Please note that the panel must be connected to WIFI for the update to go through. It may take several minutes for the panel to reboot and the update to be applied. After the process is complete. the panel will begin the re-sync process with all of the PowerG Sensors. You may notice reports of PowerG Sensors opening and closing during this time. This is normal. It may take up to 20 minutes for the re-sync process to complete. Your PowerG Zones should be operating like normal after this process.

Please note that only IQ Panel 2 Plus Systems with a PowerG radio firmware of 80.XX are affected by this upgrade. If you have a PowerG radio firmware of 4.XX, you will notice that the radio firmware does not change to 80.25. The update will still go through, but no noticeable changes will be made. Again, this is normal. If you want to check your firmware, complete the following steps:

1. Click the small grey bat at the top of the main screen.
2. Press Settings.
3. Press Advanced Settings.
4. Enter Installer Code (default 1111).
5. Press About.
6. Press PowerG.
7. Locate the Radio Firmware Version.

Below is an example of a Qolsys IQ Panel 2 Plus with radio firmware version 4.06:

If you have any questions about this radio firmware update, please email us at support@alarmgrid.com, or call us at (888) 818-7728. Keep in mind that our office hours are 9am to 8pm EST M-F. We look forward to hearing from you.